Materials of the same composition in different standards are not all DIEVAR brands, different names, but their properties should be similar. DIEVAR national standards materials have corresponding dievar brand tempering temperature, small differences are found in the combination of production conditions and capabilities of each country DIEVAR adjust the composition and process is not simply imitation and reference.
DIEVAR│UDDEHOLMDIEVAR_Characteristics of DIEVAR_Application of DIEVAR_Chemical composition
DIEVAR Overview: Swedish Uddeholm Tool Steel UDDEHOLM hot work tool steel UDDEHOLMDIEVAR developed through production processes and refinement techniques can improve tool life.
It is heated in a protective atmosphere until reaching a heating temperature of 850 degree. After heating, it is cooled at a speed of 650 degrees with the oven at 10 degrees/h, and then cooled with air.
Stress relief
After roughing, the tool should be heated to 650 degree, kept for 2 hours, cooled to 500 degree in the oven, and then air cooled.
Cooling
Preheat temperature: 600-900 degree . Usually at least two stages of preheating: 600-650 degree , the second stage at 820-850 degree . The second stage is divided into three stages at 820 degree and the third stage at 900 degree.
Austenitization temperature: 1000-1030 degree
Temperature degree holding time divided into temperatures before tempering
10003052±2HRC
10253055±2HRC
Holding time=holding time at cooling temperature after heat penetration into the steel
Protects steel from decarburization and oxidation during austenitizing
What are the characteristics of the DIEVAR?
ASSAB DIEVAR high performance Cr-Mo-V alloy mold steel, diEVAR, has good resistance to thermal cracking, breakage, thermal wear and plastic deformation.DIEVAR has the following characteristics.
⒈ excellent toughness and ductility in all directions.
⒉ good resistance to tempering.
¾ Good resistance to high temperatures.
Excellent hardening capacity.
Good dimensional stability after heat treatment and surface coating.
Chemical composition of DIEVAR, %.
In what applications is DIEVAR used?
In die casting and currently hot forging applications, ASSAB's DIEVAR die steel, hot cracking is a very common failure mechanism. DIEVAR's excellent ductility makes it resistant to hot cracking. DIEVAR's excellent toughness and hardenability further improve hot crack resistance. If hot cracking is not a major factor in mold failure, it is also possible to increase the mold hardness (2HRC) when necessary. DIEVAR is suitable for the demanding die casting, hot forging and hot extrusion industries.









