Q1: Plastic mold steel _2378 and 718 which is good
The main difference between the two in the steel manufacturing process is different and alloy trace element differences, Jinhuazhou origin of mold steel imported from Sweden Yishengbai 718 than 2738 has been kept high quality, low amount of sulfur, so What the material has the following characteristics: good polishability and photo-etching performance good processing performance higher purity and excellent homogeneity hardness uniformity
Q2: Which mold steel is better for P20 and 2378?
P20 mold steel is a kind of mold welding material, the oldest one is P20. P20 steel is suitable for making plastic molds and low melting point metal mold material. This steel has good machinability and mirror grinding properties. It has uniform hardness, good polishing and etching properties, and good machinability. Degassed and vacuum refined steel is pure and suitable for plastic molds requiring polishing or engraving. Supplied in a pre-hardened state, it can be used directly in molds without the need for additional heat treatment to shorten the working period. Forged and laminated, dense, 100% ultrasonic tested, no porosity or pinhole defects. 1.2738 Main features: Uniform material hardness 2. Excellent polishing properties 3. Good machinability 4. Pre-hardened plastic mold steel 2.-Transparent plastics such as stationery boxes, daily necessities containers and other molds with high gloss requirements. 3.-Particularly suitable for hard plastic (PS) and unbreakable plastic (ABS) parts. 4.-Refrigerators, air conditioners and other large molds with high performance requirements.
Q3: Can p20 material be heat treated and to how many degrees?
Chromium-nickel alloy steel (also known as P20 material). Material characteristics: ASSAB produces 3 types of P20 material, for 718S, 718H and 618. P20 material is hard, tough and tensile resistant, but it is not corrosion resistant and poor in wear resistance. 718H is the 718S material obtained through heat treatment of the material before leaving the factory, of which 618 material is the lowest level of these three materials, equivalent to GS2311 material, poor polishing performance, life of production of less than 100.000 times. 718S and 718H material polishing performance is good, it can be used for transparent hot polishing die, where the polishing performance of 718H is higher than 718S. The production life of these two materials is 300.000 times. Heat treatment requirements: all P20, the material in the steel factory before are pre-hardening treatment, are no longer suitable for quenching treatment. p20 quenching material easy to burst, can only be surface nitriding treatment, oxidation requirements for the surface of 0.1mm, hardness of 65 ~ 68HRC. Processing requirements: P20 cutting material performance is general, when the minimum size of P20 material is greater than 300mm, if in the processing process When the minimum size of P20 material is greater than 300mm, if there is a lot of wire cutting or EDM process, after the wire cutting or EDM process is completed, tempering should be done.
Q4: What is the hardness of p20 and 718?
The 718 is only available in Sweden, it is actually the 738, but the company changed its name to 718 to distinguish the traditional name. 718=P20 + 1% Ni. P20 is generally used for plastic molds with few requirements, or inferior plastic molds. 718 has good polishing properties and is generally used for plastic molds with polishing requirements, the hardness of 718 steel is 4HRC higher than that of p20. Some of the domestic steel factories also agreed with the ratio of 718 in the launch of the domestic 718.
So the above content is about plastic mold steel _ 2378 and 718 which is good for some information, I hope this article can help the network to get some of the content they want to understand. Steel mold P20 and 2378 that good is a small collection of collated summary, I hope it can bring help.







